Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Oxidis

Pages: 1
Ask a Question / Re: Set attributes for specific actors ?
« on: June 24, 2014, 09:27:19 pm »
If I was faced with that problem, I would try making an invisible block (another actor) that the elevator cannot move past. Then I would put that block above and below each elevator to define their upper and lower limits.

Or try reading this:

Ask a Question / Re: My actors are falling tro the tiles
« on: June 23, 2014, 08:35:16 pm »
Did you add behaviours or events that stops the actors from falling through tiles?
If not, try adding the "Walking" behaviour.

Pages: 1